Up to Four Light Positions
The tiered bracket design provides two mounting positions on each side, allowing a single pod setup or a dual-light combination based on your preferred beam pattern and lighting needs.
Powder-Coated Aluminum Alloy
High-strength aluminum-alloy construction provides a rigid mounting platform, while the black corrosion-resistant finish is designed for everyday outdoor and off-road conditions.
Factory-Point Installation
Installs at the original Bronco A-pillar mounting locations using the factory holes and fasteners without drilling, cutting, or permanent body modification.
Designed for Direct Installation
Installation
Designed for direct installation with the instructions and tools needed for setup.
DIY Friendly
Designed for direct installation without professional help.
Instructions Included
Follow the supplied guide during installation.
Tools Included
The necessary installation tools are provided.
Support Available
Contact Mabett for additional installation guidance.
Vehicle compatibility
Fitment
Confirm your model year and trim before ordering.
Compatible
Fits These Mavericks
2021–2026 Ford Bronco
2-Door models
4-Door models
Not compatible
Does Not Fit
Ford Bronco Sport
Frequently asked questions
Before You Order
Quick answers about fitment, installation, protection, and care.
Are the auxiliary lights and wiring included?
No. The package includes one driver-side and one passenger-side A-pillar mounting bracket only. Auxiliary lights, light-specific mounting hardware, wiring harnesses, relays, switches, connectors, and electrical components must be purchased separately.
Can I install two lights on each side, and will every pod light fit?
The tiered design provides up to two mounting positions on each side, allowing as many as four lights across the vehicle. Actual compatibility depends on the light’s mounting-stud diameter, base width, housing size, wire exit, and available clearance. Test-fit every light before completing the wiring, especially when using large housings or two lights on one bracket.
Does no-drill installation mean no wiring work is required?
No. The brackets install at the factory A-pillar mounting points without drilling or cutting, but the auxiliary lights still require their own wiring and switching system. Wiring difficulty depends on the selected lights, harness, connectors, and Bronco equipment. Route every wire away from hood hinges, sharp edges, heat, and moving components.
Will the brackets eliminate wind whistle from A-pillar lights?
No wind-noise reduction is guaranteed. Whistling is usually affected by the selected light housing, cooling-fin design, mounting position, and aiming angle rather than the bracket alone. Repositioning the lights or using compatible covers may change the noise, but results will vary.
